Learn Switching Chords With Strumming Patterns Practice

Published on by Ashish

In this lesson we will learn how to incorporate bass notes into our strumming patterns. Now, we'll explore that concept further, except now we'll try and incorporate single notes within the chord with our strumming patterns.

The primary reason beginners have trouble switching chords quickly has nothing to do with their fingers, or the way they're sitting, or anything physical at all. Most often, new guitarists haven't learned to think ahead, and visualize exactly which chord they're about to play, and which fingers they'll need to move.

This one will be tricky at first, but as your picking accuracy increases, it'll sound better and better. In your fretting hand, hold down a Gmajor chord, with your second finger on the sixth string, first finger on the fifth string, and third finger on the first string. Now, strike the sixth string with your pick, and follow that by down and up strums on the bottom four strings of the chord. Use the above tablature to complete the rest of the pattern. When finished playing the pattern once, loop it multiple times. Be sure to keep your picking motion constant, whether you are playing a single note, or strumming a chord. If you are too deliberate while playing the single notes, it will break the flow of your strum, and the resulting pattern will sound choppy.

Try this exercise:

Choose two chords you know. You will be moving back and forth between these two chords.
Play the first chord eight times (strumming evenly), and then, without breaking the rhythm of your strumming, quickly move to the next chord, and play that chord eight times.

Did you need to pause while switching chords? If so, let's try and examine what the problem is. Try the following, without strumming the guitar:

Put your fingers back in position to play the first chord.
Now, try and move quickly to the second chord, and study your fingers while doing so.

Chances are, one (or a few) of your fingers will come way off the fretboard, and perhaps hover in mid-air while you try to decide where each finger should go. This happens, not because of any lack of technical ability, but because you haven't mentally prepared yourself for switching chords.

Now, try fretting the first chord again. Without actually moving to the second chord, visualize playing this second chord shape. Picture in your mind, finger by finger, how to most efficiently move to the next chord. Only after you've done this should you switch chords. If some fingers continue to pause, or hover in mid air while moving to the next chord, back up and try again. Also, concentrate on "minimum motion" - commonly, beginners bring their fingers very far off the fretboard while switching chords; this is unnecessary. Spend five minutes going back and forth between the two chords, visualizing, then moving. Pay attention to any small, unneccessary movements your fingers make, and eliminate them. Although this is easier said than done, your hard work and attention to detail will start paying off quickly. Good luck!

To find out more information on playing guitar, tips and trouble shooting, visit My Blog.

Published on Music

To be informed of the latest articles, subscribe:

Comment on this post